|
|
| Product Description: |
Garage Door Holder Model 1011 for Fixing to Narrow Lintels from Cookson Hardware.
Product Reference: 10110000BK
Garage door holders are designed to hold open side hung garage doors at approximately 90 degrees. The door is released from the held open position by pulling the pull cord. Ideal for situations where the door cannot be propped open, the holder engages and will hold the door open until the cord is pulled to release it. This product is not suitable for fire doors. Supplied complete with fixings. Sold in single units (half pairs).
The 1011 model is suitable for fixing to the side of narrow lintels.
The lintel fixing plate is approximately 90mm x 90mm.
Size:
600mm overall length.
Finish:
Black
Fixing instructions;
- Open the door to right angles
- Fix bracket "A" to lintel at distance of 430mm from the centre of the hinge pin to the centre of the swivel plate.
- While the door is open at right angles, fix bracket "B" to the door ensuring the bar is horizontal
- If the door is required to open wider than 90 degrees, both brackets must be moved nearer to the hinge
Fixing diagram for 1011 garage door holder for wide lintels
Click the image above to enlarge.
Images may vary slightly than the product shown depending on current stocks.
|
| Similar products can be found in these categories: |
Door Hardware
>Door Holders & Stays
>
Garage Door Stays
All Perry Hinges and Ironmongery Products
|
; "Garage Door Holder 1011 600mm for Narrow Lintel Black per Single")
